Metal Cutting Band Saws—Manual, Gravity Feed & Semi-Automatic

Pedrazzoli Brown horizontal band saws are built for accurate cutting of ferrous and nonferrous tube, pipe, solids and structural profiles. Both models use heavy cast-iron bases to reduce vibration during the cut, supporting straighter parts, longer blade life and more consistent results.

Choose the SN 300 Newton manual gravity-feed band saw for everyday cutoff and miter work with round capacity up to 8.7 inches at 90°. Step up to the Brown SN 420 SA semi-automatic band saw when you need hydraulic clamping, controlled bow movement, automatic bow return and capacity up to 11 inches round at 90°.

Both machines miter in two directions—up to 60° left and 45° right—and are sold and supported in the Americas by CML USA in Davenport, Iowa. Customers have a U.S. source for demonstrations, replacement blades, spare parts and factory-trained service.

Compare Pedrazzoli Band Saw Models

SN 300 Newton Manual Gravity-Feed Band Saw

The SN 300 Newton gives shops a simple, dependable way to cut tube, pipe, profiles and solids without the cost or complexity of a fully automatic machine. Its gravity-controlled dynamic feed lets the balanced bow descend through the material, while a flow regulator allows the operator to control cutting pressure.

The saw cuts round material up to 8.7 inches at 90° and miters up to 60° left and 45° right. A large rotating miter table supports the material as the saw head changes angle.

Brown SN 420 SA Semi-Automatic Band Saw

The Brown SN 420 SA adds a hydraulic vise, controlled bow movement, foot-pedal cycle start and automatic bow return. It is designed for shops that make repeated cuts but still position the material manually.

With round capacity up to 11 inches at 90°, dual-direction mitering and manual or semi-automatic operating modes, the SN 420 SA is the production-oriented choice in the Pedrazzoli band saw line.

Pedrazzoli Virtual Tour

Manual or Semi-Automatic—Which Band Saw Do You Need?

Choose a manual gravity-feed band saw when production volume is moderate, cut lengths change frequently and an operator can reset the machine after each cut. The SN 300 Newton is a strong fit for maintenance departments, job shops and general fabrication.

Choose a semi-automatic band saw when repeated operator motions are slowing production. The Brown SN 420 SA controls the cutting cycle and bow return, helping different operators achieve more consistent results.

If you are unsure, tell CML USA what material you cut, the largest section, required miter angles and approximate number of cuts per shift. We will help match the machine to the application.

Band Saw or Circular Cold Saw?

A band saw is usually the more flexible choice for large sections, solids and mixed profiles. A circular cold saw is often the better choice when cycle speed and a burr-free, weld-ready finish are the highest priorities on tube and profiles.

Many fabrication shops use both: a band saw for larger or changing material and a cold saw for fast production cutoff work.

U.S. Blades, Parts, Demonstrations and Service

Pedrazzoli band saws are sold and serviced in the Americas by CML USA, Inc. in Davenport, Iowa. Customers can arrange a machine demonstration and have a U.S. source for replacement blades, spare parts, application assistance and technical service.

Request a Band Saw Recommendation or Quote

Send us your material type, largest section, cut angle and production requirements. We will help determine whether the SN 300 Newton or Brown SN 420 SA is the better fit.

Sold and serviced in the USA — CML USA, Inc., Davenport, Iowa. Machines under power for demonstration, spare parts and blades in stock, and factory-trained technicians serving fabricators across North and South America.